Section 3 (Basic Engine V6)
WARNING: This page is about a different variant/trim than selected.
- Repair Instructions
- Power train removal
- Power unit, fitting
- Timing cover
- Timing cover in car
- Replacing the engine (power train on the subframe)
- Valve guide seal
- Valve spring, rear
- Valve mechanism, rear cylinder head, B284 (old version)
- Valve cone, front (old version)
- Valve mechanism, front cylinder head, B284 (old version)
- Rear camshaft cover
- Front camshaft cover
- Camshaft covers, removed engine
- Engine compression test
- Drive belt, auxiliaries
- Engine mounting, right
- Engine mounting, left-hand
- Fitting of right-hand torque arm
- Belt tensioner
- Crankshaft pulley
- Front crankshaft seal
- Rear crankshaft seal in car
- Rear crankshaft seal
- Solenoid valve, intake camshaft, front cylinder bank (695F)
- Solenoid valve seal, intake camshaft, front cylinder bank (695F)
- Solenoid valve, intake camshaft, rear cylinder bank (695R)
- Solenoid valve seal, intake camshaft, rear cylinder bank (695R)
- Camshaft drive, B284 (old version)
- Check the engine oil pressure
- Oil pressure switch
- Oil sump
- Oil pump
- Level sensor, engine oil (243)
- Oil filler pipe
- Rear torque arm
- Front torque arm
- Spark plug
- Cylinder head, B284
- Description and Operation
- Component Locator
- Specifications
- Special Tools and Equipment
- EN-46103 Fitting Tool
- EN-46105 Adjustment Tool
- EN-46106 Flywheel Locking Attachment
- EN-46108 Fixing Tool
- EN-46109-2 Centering tool
- EN-46110 Valve Spring Depressors
- EN-46111 Sleeve
- EN-46117 Fitting tool
- EN-46121 Guide pin
- EN-47635 Fitting tool
- EN-47839 Fitting tool
- EN-47981 Holding Tool, Pulley
- EN-47982 Puller
- J-24254-A Fitting tool
- J-41818 Removal tool
- J-41998 Fitting Tool
- J-43654 Removal/fitting tool
- J-5590 Drift
- 32 025 037 Hook for lifting yoke
- 32 025 048 Holder
- 32 025 051 Oil filter spanner
- 32 025 053 Holder
- 32 025 059 Support
- 32 025 060 Tool kit
- 32 025 061 Crow foot spanner
- 32 025 062 Crow foot spanner
- 83 95 360 Support, crankshaft belt pulley
- 83 94 173 Air nipple for spark plug hole
- 87 92 574 Holder
- Schematic and Routing Diagrams