LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4L60-E/4L65-E - Introduction & Repair Procedures >> Repair Instructions >> Transmission Extension Housing Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Case Extension, Bolts & O-Ring Seal
    GM656358Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Support the transmission with a transmission jack.
  3. Place a drain pan under the vehicle.
  4. Remove the propeller shaft. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft.
  5. Remove the transmission mount. Refer to Transmission Mount Replacement (4.2L)  or Transmission Mount Replacement (5.3L) .
  6. Remove the case extension bolts (1).
  7. Remove the case extension (2).
  8. Remove and discard the case extension O ring seal (3).
scientia non olet · About LEMON Manuals