LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4L60-E/4L65-E - Introduction & Repair Procedures >> Repair Instructions >> Automatic Transmission Range Selector Cable Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Range Selector Cable
    GM744174Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the vehicle is in the park position.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the end of the range selector cable from the transmission range selector lever ball stud (6).
  4. Remove the retainer (5) from the range selector cable.
  5. Remove the range selector cable (4) from the bracket (1).
  6. Remove the cable from the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, remove the cable from the retainers located on the transfer case.
    7. Fig 2: Pushing Cable Grommet Up Through Floor Panel
    GM744168Courtesy of GENERAL MOTORS CORP.
  7. Push the cable grommet (2) up through the floor panel.
  8. Lower the vehicle.
    9. Fig 3: Removing/Installing Center Console Assembly
    GM1234306Courtesy of GENERAL MOTORS CORP.
  9. Remove the console. Refer to Console Replacement in Instrument Panel, Gauges, and Console.
  10. Remove the drivers side front mat and carpet. Refer to Carpet Replacement - Front in Interior Trim.
    11. Fig 4: View Of shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  11. Remove the end of the range selector cable (1) from the floor control ball stud.
  12. Remove the range selector cable (2) from the floor shift control assembly.
  13. Remove the tape and grommet on the shift cable from the floor panel.
  14. Remove the range selector cable (3) from the vehicle.
scientia non olet · About LEMON Manuals