LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4L60-E/4L65-E - Introduction & Repair Procedures >> Repair Instructions >> 2-4 Servo >> Installation Procedure

Installation Procedure

  1. Install new seals on the servo pistons and the servo cover.
    2. Fig 1: View Of 2-4 Servo
    GM642523Courtesy of GENERAL MOTORS CORP.
  2. Install the 2-4 servo assembly into the transmission.
  3. Install the J 29714-A  . See Special Tools .
    4. Fig 2: Compressing The Servo Cover Using J 29714-A
    GM14478Courtesy of GENERAL MOTORS CORP.
  4. Tighten the bolt in order to compress the servo cover.
  5. Install the servo cover retaining ring.
  6. Remove the J 29714-A  from the oil pan flange.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the transmission oil pan bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  8. Install the heat shield if equipped. Refer to Heat Shield Replacement .
  9. Install the exhaust pipe assembly. Refer to Catalytic Converter Replacement (4.2L Engine) or Catalytic Converter Replacement (5.3L Engine) in Engine Exhaust.
  10. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  11. Remove the transmission jack.
  12. Lower the vehicle.
  13. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals