LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Column Trim Covers Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Upper Trim Cover & Screws
    GM415299Courtesy of GENERAL MOTORS CORP.
  1. Install the upper trim cover (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining screws (1) to the upper trim cover (2).

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

    3. Fig 2: View Of Lower And Upper Steering Column Covers
    GM328807Courtesy of GENERAL MOTORS CORP.
  3. Install the lower trim cover by matching the tabs slots on the trim cover with the locking tabs on the upper trim cover and tilting the lower trim cover up.
    4. Fig 3: Removing/Installing Trim Covers
    GM1623158Courtesy of GENERAL MOTORS CORP.
  4. If necessary, install the toggle switch into the lower trim cover.
  5. Install the retaining screws to the lower trim cover.

    Tighten:  Tighten the screws to 3.5 N.m (31 lb in).

  6. Connect the toggle switch.
  7. Install the tilt lever to the steering column. Refer to Tilt Lever Replacement .
  8. Install the steering wheel. Refer to Steering Wheel Replacement .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals