LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 5.3L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.
    Fig 1: Removing/Installing Manifold Absolute Pressure (MAP) Sensor
    GM1509706Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1). Push the MAP sensor into the intake manifold.
  2. Install the MAP sensor retainer (2) to the intake manifold.
    3. Fig 2: Top Of Engine Wiring Harness View
    GM898326Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAP sensor electrical connector (3).
scientia non olet · About LEMON Manuals