Installation Procedure

Fig 1: View Of Front Door Sealing Weatherstrip

Courtesy of GENERAL MOTORS CORP.

Install the side reveal molding (2) to the windshield pillar. Ensure the bottom edge is tucked under the outer edge of the air inlet panel grille.

Fig 2: Identifying Windshield Reveal Molding Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the side reveal molding.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: Removing/Installing Weather-Strip Retainers

Courtesy of GENERAL MOTORS CORP.

Install the push-pin retainers (2) to the front door sealing auxiliary weatherstrip located at the base of the pillar.
Close the door.