LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Body & Frame >> Seats >> Repair Instructions >> Seat Back Replacement - Front >> Installation Procedure

Installation Procedure

  1. Install the seat back to the seat adjuster.
    2. Fig 1: Removing/Installing Seat Back Recliner Arm Bolts
    GM752837Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat back to the seat back recliner arm with the 2 bolts.

    Tighten:  Tighten the bolts for the seat back recliner arm to 55 N.m (41 lb ft).

    3. Fig 2: Removing/Installing Seat Back Pivot Bolt
    GM752830Courtesy of GENERAL MOTORS CORP.
  3. Install the seat back pivot bolt.

    Tighten:  Tighten the seat back pivot bolt to 35 N.m (26 lb ft).

    4. Fig 3: Removing/Installing Seat Back Cover Over Seat Back Pad
    GM752842Courtesy of GENERAL MOTORS CORP.
  4. Pull the seat back cover down over the seat back pad.
  5. Attach the hook and loop retaining strips by running your hand over the seat cover.
    6. Fig 4: Identifying Bottom Seat Back Cover J-Strips, Cover Flaps & Push Pins
    GM752846Courtesy of GENERAL MOTORS CORP.
  6. Fasten the J-strips (1,4) across the bottom of the seat back cover.
  7. Install the seat cover flaps (2) to the seat frame with pushpins (3).
    8. Fig 5: Removing/Installing Seat Belt Anchor Nut
    GM752863Courtesy of GENERAL MOTORS CORP.
  8. Install the seat belt anchor.

    Tighten:  Tighten the seat belt anchor nut to 55 N.m (41 lb ft).

  9. Install the seat cushion trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  10. Install the front bucket seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals