LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Body & Frame >> Seats >> Repair Instructions >> Lumbar Support Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Lumbar Mechanism Cable End
    GM755853Courtesy of GENERAL MOTORS CORP.
  1. Hook the cable end into the lumbar mechanism.
    2. Fig 2: Lumbar Mechanism View
    GM755852Courtesy of GENERAL MOTORS CORP.
  2. Install the cable to the lumbar spring.
    3. Fig 3: Removing/Installing Lumbar Cable & Cable Clip
    GM755850Courtesy of GENERAL MOTORS CORP.
  3. Install the lumbar cable (2) in the cable clip (1) located on the lower seat back.
    4. Fig 4: Removing/Installing Seat Adjuster Cable Screws
    GM755848Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install 2 screws (1) securing the cable to the seat adjuster.

    Tighten:  Tighten the lumbar cable screws to 6 N.m (53 lb in).

  5. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
  6. Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  7. Install the seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals