Installation Procedure

Fig 1: Disconnecting/Connecting Inline Connector At Sunroof Electrical Harness Disconnected

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Ensure that the drive gear is fully indexed and seated to the drive cables.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screw that retains the sunroof control module to the mounting bracket.
Tighten: Tighten the sunroof control module screw to 3 N.m (27 lb in).
Connect the 2 electrical connectors to the sunroof control module.
Install the sunroof motor/actuator to the sunroof module assembly. Refer to Sunroof Motor/Actuator Replacement .
With an assistant, install the sunroof module assembly to the vehicle. Refer to Sunroof Module Assembly Replacement .
Connect the inline connector on the sunroof electrical harness.
Install the headliner. Refer to Headliner Replacement in Interior Trim.