Removal & Installation
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Air bag control module is located under rear of center console, behind parking brake. Engage parking brake. Remove ignition switch cover by prying up left front edge and loosening rear and front edges. Disconnect ignition switch lighting connector and remove 2 floor console screws. Remove rear ashtray and Torx bolt at rear cover. Remove 2 floor console securing nuts and then pull back and up on console.
- Pry out interior lighting switch and disconnect electrical connector. Remove and disconnect heated rear seat switch. Remove electric window module by prying upward on front edge, and then disconnect connector. Lift off floor console to expose air bag control module. See Fig 1. Remove 3 nuts and disconnect electrical connector.
- To install, reverse removal procedure. Ensure connector points toward driver seat. Activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .