LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2002 >> 9-3 SE, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Modules, Relays & Solenoids >> Relays >> Limp-Home Solenoid Relay

Limp-Home Solenoid Relay

  1. Remove limp-home solenoid relay from instrument panel relay block. See Figure or Figure . Measure resistance between limp-home solenoid relay terminals No. 3 and No. 5. Resistance should be 70-80 ohms at 68°F (20°C). If resistance is not as specified, replace relay. Check for continuity between relay terminals No. 1 and 2. If continuity is not present, go to next step. If continuity is present, replace relay.
  2. Using jumper wires, apply battery voltage to terminal No. 3 and ground to terminal No. 5. See Figure. Measure resistance between relay terminals No. 1 and 2. If continuity is not present, replace relay. If continuity is present, inspect associated wiring for short or open circuits. See WIRING DIAGRAMS article. Repair wiring as necessary.
scientia non olet · About LEMON Manuals