LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2002 >> 9-3 SE, 2D Convertible, Standard >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Fault Diagnosis, General >> Testing For Open/Short Circuits >> Testing For Open Circuits By Measuring Resistance

Testing For Open Circuits By Measuring Resistance

Fig 1: Measuring Open Circuit Resistance
G03528925Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fig 2: Testing For Open Circuit
G03528926Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Make sure the component or lead to be tested is not under tension (e.g. by removing the relevant fuse).
  2. Set the multimeter for measuring ohms and connect the ohmmeter to each end of the component/lead to be tested.
  3. Jiggle the relevant wiring harness while observing the ohmmeter.

    Normally, the resistance of a wiring harness is less than 1 ohm. Specified values apply to components.

scientia non olet · About LEMON Manuals