Service Precautions: Notes

Observe these precautions when working with air bag systems:

• Disable SRS before servicing any SRS or steering column component. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
• Wait about 10 minutes after deactivating air bag system. System maintains air bag system voltage for some time after battery is disconnected. Servicing air bag system before 10 minutes may cause accidental air bag deployment and possible personal injury.
• Because of critical operating requirements of system, DO NOT attempt to service air bag components. Corrections are made by replacement only.
• Always wear safety glasses when servicing or handling an air bag.
• Handle air bag components carefully. Avoid exposing components to impact, heat, moisture, etc.
• Air bag modules and belt tensioners must be installed immediately after they have been taken out of storage. If work is interrupted, module must be returned to storage. Air bag modules and belt tensioners must never be left unattended out of storage.
• Air bag module is a sealed unit. DO NOT attempt to dismantle or repair it.
• Seat belt tensioner modules are sealed units. DO NOT attempt to dismantle or repair.
• When placing a live air bag module on a bench or other surface, always face air bag and trim cover up, away from surface. This will reduce motion of module if accidentally deployed.
• After deployment, air bag surface may contain deposits of sodium hydroxide, which can irritate skin. Always wear safety glasses, rubber gloves and long-sleeved shirt during clean-up. Wash hands using mild soap and water. Follow correct disposal procedures. See DISPOSAL PROCEDURES  .
• Never allow any electrical source near inflator on back of air bag module.
• When carrying a live air bag module, trim cover should be pointed away from your body to minimize injury in case of accidental deployment.
• Never apply grease to SRS connectors.