Fuel Injectors
- Disconnect battery ground cable and relieve fuel system pressure. Disconnect or remove all components, wiring and vacuum hoses as required to gain access to injectors.
- Disconnect electrical connectors from injectors.
- Remove injector clamps at fuel rail. Remove injectors from fuel rail by melting hose lengthwise with a soldering gun until injector can be removed from rail. Thoroughly clean fuel rail of rubber.
- To install, reverse removal procedure. Install injectors on fuel rail with new hose and ensure hose is fully seated on injector and fuel rail. Connect hose with a clamp. Ensure injector seals are properly installed.