Changes, Cautions, Corrections

CLUTCH RELEASE LEVER CHANGE  - All models are equipped with a cast type clutch release lever. This new lever replaces the welded "two-section" stamped sheet metal lever. The two piece lever is no longer being produced. When replacing an early lever with a new cast type, it is necessary to modify cable support bracket to allow clearance between cast type lever and bracket.

CLUTCH HOUSING SEAL CORRECTION  - To improve the sealing of clutch housing on all models, three new rubber pads have been designed. The use of these rubber pads prevents water and other foreign material from getting to clutch release bearing and starter bendix.