Removing Spring Strut Mount
WARNING: This page is about a different car, the 2021 Porsche Panamera, 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.
Installation position of spring strut mount
- Disconnect connection points.
Disconnecting connection points
- 1.1 Remove punch rivets -A- using > VAS 852 001 - Body Dent Removal System, Aluminium and > VAS 6790 - Compact Booster.
- 1.2 Drill through clinch points -B- using a > Diameter 6.6 mm carefully.
- Disconnect connection points.
Disconnecting connection points
- 2.1 Unscrew self-tapping screws -1- .
- 2.2 Remove punch rivets -A- using > VAS 852 001 - Body Dent Removal System, Aluminium and > VAS 6790 - Compact Booster.
- 2.3 Drill out spotwelds -B- .
- Heat up bonding areas.
Heating up bonding areas
- Remove closing element for longitudinal member.
- Unscrew self-tapping screws -1-
.
Unscrewing self-tapping screws
- Remove punch rivets using > VAS 852 001 - Body Dent Removal System, Aluminium
and > VAS 6790 - Compact Booster.
> 5X00IN REPLACING PUNCH RIVETS AND PENETRATED JOINTS
Removing punch rivets
Removing punch rivets
- Drill through clinch points using a > Diameter 6.6 mm
.
Drilling out clinch points
- Separate ground connection from longitudinal member to spring strut mount.
Separating ground connection
- Heat bonding areas. > V.A.G 1416 - Hot-Air Blower
Heating up bonding areas
Heating up bonding areas
- Remove spring strut mount.