Installing Front Display And Operator Control Unit

Information 

Always comply with the regulations for handling ESD - sensitive components!

• Always wear approved work clothes and shoes when carrying out assembly work. 
• Do not remove new part from ESD (electrostatic discharge) protective packaging until shortly before installation and only at the installation position. 
• Do not touch electric pins and plug contacts. 

Information 

Make sure that all rubber spacers are fitted on the front display and operator control unit. The rubber spacers can get lost during removal.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Tighten fastening screws to > Tightening torque 1.5 (1 ftlb.) Nm  .