DTC U2007-98: Valve(s) - Component or system over temperature: Action
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2015 Land Rover Range Rover, and 2014 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Check pipe work and replace as required
- Check the operation of the cooler unit and replace as necessary
- Drain reservoir and inspect mesh filter for signs of significant contamination. Identify source of contamination (check condition and operation of dynamic response actuators and hydraulic pump) and rectify as required. Flush dynamic response hydraulic fluid circuit and recharge with clean hydraulic fluid
- Investigate driving profile
- Clear the DTCs and retest. If the fault persists, check the operation of the pressure control valve. If a valve fault is noted, check and install a new valve block as required and reset adaptive data