DTC P0810-62: Clutch Position Control Error - Signal compare failure: Action
WARNING: This page is about a different car, the 2018 Land Rover Discovery and 2017 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
After installing a new rear differential control module, differential locking motor or electric differential, clear the DTCs and calibrate the system by performing routine - On Demand Self Test.
- Refer to the electrical circuit diagrams and check the differential locking motor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness or install a new differential locking motor as necessary
- Refer to the electrical circuit diagrams and check the differential locking motor position sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness or install a new differential locking motor as necessary
- Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTCs and perform routine - On Demand Self Test. If the fault persists, install a new differential locking motor