DTC C1119-62: Hydraulic Pressure - Signal compare failure: Action
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2015 Land Rover Range Rover, and 2014 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Check and top up the hydraulic fluid as required
- Check integrity of hydraulic system and rectify any leaks as required. Carry out manual bleed procedure. Clear the DTCs and retest
- If the fault persists, install a new valve block. Clear the DTCs and retest
- If the fault persists, install a new pressure transducer. Clear the DTCs and retest
- If the fault persists, install a new filter. Clear the DTCs and retest
- If the fault persists, check the operation of the front and rear actuators and install new actuator(s) as required. Clear the DTCs and retest
- If the fault persists, install a new drop link (s) or stabilizer bar(s). Clear the DTCs and retest