DTC C1A07-62: Cross Articulation - Signal compare failure: Action
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2015 Land Rover Range Rover, and 2014 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If any height sensor fixings were slackened or found to be loose or if a height sensor was changed, the vehicle ride height MUST be recalibrated
- Visually inspect the height sensors, height sensor linkages and height sensor brackets for security, damage and correct orientation/installation. Check the sensor connectors for damage. Repair/renew as required. If any sensors, linkages or brackets require attention, re-calibrate the ride height using the Jaguar Land Rover Approved Diagnostic Equipment. Clear the DTCs and retest
- If the fault persists, re-calibrate the ride height using the Jaguar Land Rover Approved Diagnostic Equipment. Clear the DTCs and retest
- If the fault persists, refer to the appropriate system wiring diagram and check height sensor circuits for short circuit to ground, short circuit to power, short to another circuit, open circuit, high resistance. Repair circuit (s) as required, clear the DTCs and retest
- Check that correct tires are fitted and check tire pressures. Rectify as necessary. Clear the DTCs and retest
- If the fault persists, check that the vehicle is free of obstructions. Check the height sensor(s) for correct installation and torque of fixings. If any fixings require attention, re-calibrate the ride height using the Jaguar Land Rover Approved Diagnostic Equipment. Clear the DTCs and retest
- If the fault persists, install new height sensor(s)