Section 410 (Diagnostic Trouble Code Index DTC: BLINDSPOT Monitoring Control Module (BMCM) - (Left/Right) -- Discovery Sport/L550)
WARNING: This page is about a different car, the 2018 Land Rover Discovery Sport, 2017 Land Rover Discovery Sport, 2016 Land Rover Discovery Sport, and 2015 Land Rover Discovery Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Trouble Code Index DTC: Blindspot Monitoring Control Module (BMCM) - (Left/Right)
- Description And Operation
- Blind Spot Monitoring Control Module (BMCM) - Left/Right
- DTC B12DA-01: Blind Spot Warning Indicator - General electrical failure
- DTC U0055-86: Vehicle Communication Bus D - Signal invalid
- DTC U0055-87: Vehicle Communication Bus D - Missing message
- DTC U0055-88: Vehicle Communication Bus D - Bus off
- DTC U0232-87: Lost Communication With Side Obstacle Detection Control Module - Left - Missing message
- DTC U0233-87: Lost Communication With Side Obstacle Detection Control Module - Right - Missing message
- DTC U0300-00: Internal Control Module Software Incompatibility - No sub type information
- DTC U0300-57: Internal Control Module Software Incompatibility - Invalid/incomplete software component
- DTC U0533-86: Invalid Data Received From Side Obstacle Detection Control Module-Left - Signal invalid
- DTC U0534-86: Invalid Data Received From Side Obstacle Detection Control Module-Right - Signal invalid
- DTC U0556-09: Invalid Data Received From Front Display Interface Module - Component failures
- DTC U1A00-88: Private Communication Network - Bus off
- DTC U2100-00: Initial Configuration Not Complete - No sub type information
- DTC U2101-00: Control Module Configuration Incompatible - No sub type information
- DTC U3000-45: Control Module - Program memory failure
- DTC U3000-46: Control Module - Calibration/parameter memory failure
- DTC U3000-49: Control Module - Internal electronic failure
- DTC U3000-56: Control Module - Invalid/incomplete configuration
- DTC U3000-78: Control Module - Alignment or adjustment incorrect
- DTC U3000-97: Control Module - Component or system operation obstructed or blocked
- Description And Operation