DTC P0942-71: Hydraulic Pressure Unit - Actuator stuck: Action
WARNING: This page is about a different car, the 2018 Land Rover Discovery Sport, 2017 Land Rover Discovery Sport, 2016 Land Rover Discovery Sport, and 2015 Land Rover Discovery Sport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The All Wheel Drive System Pump Bleed routine must be performed after all rear drive unit hydraulic system repairs.
- Using the Jaguar Land Rover approved diagnostic equipment, reconfigure the all wheel drive control module with the latest level software. Clear the DTCs, road test the vehicle and retest
- If the DTC returns, refer to the appropriate system wiring diagram and check the rear drive unit pump circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Check the rear drive unit hydraulic pipes for damage/blockages
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new all wheel drive control module.
For additional information, refer to: DIFFERENTIAL CONTROL MODULE