LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2009 >> Cayenne Base, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> 69 Occupant Protection/Personal Protection >> WM 695319 Removing And Installing Triggering Unit For Airbag (All Models) >> Removing Triggering Unit For Airbag

Removing Triggering Unit For Airbag

Fig 1: Overview Of Airbag Triggering Unit
G09412887Courtesy of PORSCHE CARS NORTH AMERICA, INC.
WARNING: Incorrect handling of airbag units
  • Triggering of airbag unit
  • System faults can occur

→ Switch off ignition and remove ignition key or remote control (hand-held transmitter).

→ A voltage supply (e.g. battery charger) must not be connected to the external power supply/jump-lead starting terminals.

→ Disconnect the battery and insulate the ground strap so that all contact with a ground carrier is avoided.

→ Wait 1 minute after disconnecting the battery.

→ Only detach connector on the triggering unit after the waiting time has elapsed.

→ Make sure that no foreign objects are located in front of the airbag unit during installation.

→ Replace damaged parts during removal.

→ Always position airbag units so that the blow-out opening is facing upwards, e.g. crest on driver's airbag.

→ Do not position anything on the airbag units.

→ If removed for an extended period, the airbag units must be stored in a safe place.

→ Airbag units must not come into contact with grease, oil, detergents, liquids, or similar substances.

→ Do not expose airbag units to temperatures above 90°.

→ Do not remove the short-circuit spring on the plug-in contacts.

→ Ignition and preparations may only be carried out by skilled staff, supervised by a second responsible person.

→ Before disposal, the airbag unit must be rendered harmless by electrical ignition performed in accordance with all precautionary measures, thereby preventing it from being used incorrectly.

  1. -arrow A-  Fold up storage compartment.
    Fig 2: Removing Shelf Cover
    G09412888Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Unscrew fastening screws and remove cover -arrow B-  .
    Fig 3: Removing Shelf Cover
    G09412889Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Lift rear trim of centre console (unclip 4x), disconnect plug and remove.
    Fig 4: Removing Rear Trim Of Centre Console Plug
    G09412890Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Fold up centre console trim to the front.
  5. Push in -arrow C-  plug lock -arrow 1-  , fold over lever -arrow 2-  and pull off connector.
    Fig 5: Removing Triggering Unit
    G09412891Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Unscrew fastening nuts -arrow D-  .
    Fig 6: Removing Triggering Unit
    G09412892Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Remove the triggering unit.