Diagnosis/troubleshooting VG 0101
NOTE:
If there is no incoming signal/message via the CAN drive using several control modules, the CAN drive must be checked for open or short circuits. Refer to ' CHECKING INSTRUCTIONS/CAN DATA BUS '.
DIAGNOSIS TROUBLESHOOTING PROCEDURE
| Work instruction | Display OK | If not OK | |
|---|---|---|---|
| 1 | Read out fault memory for Tiptronic control module (fault localisation) | For further fault localisation, please follow the diagnosis/troubleshooting instructions for the Tiptronic control module, refer to the TIPTRONIC
and AUTOMATIC - ACTUATION, ASSEMBLY HOUSING
articles.
. → End |
|
| 2 | CHECKING INSTRUCTIONS/CAN DATA BUS . | → End | |