Diagnosis/troubleshooting G 0210
NOTE:
If there is no incoming signal via the CAN drive using several control modules, the CAN drive must be checked for open or short circuits. Refer to 'CHECKING INSTRUCTIONS/CAN DATA BUS
'.
DIAGNOSIS/TROUBLESHOOTING PROCEDURE
| Work instruction | Display OK | If not OK | |
|---|---|---|---|
| 1 | Read out PSM control module fault memory | For further troubleshooting, please follow the diagnosis instructions for the PSM control module in the PSM
article
. → End |
|
| 2 | CHECKING INSTRUCTIONS/CAN DATA BUS . | → End | |