OBD (II) - P0010 - P0199: P0121: Diagnosis/troubleshooting
NOTE:
- The system is in stand-by operation mode in pedal sensor, i.e. the accelerator pedal angle is calculated from the remaining potentiometer signal.
- When this fault occurs, the value from the pedal sensor is limited to 30% and the dynamic is reduced.
WORK INSTRUCTION CHART
| Work instruction | Display OK | If not OK | |
|---|---|---|---|
| 1 | Replace pedal sensor and perform a kickdown adaptation using the 9588 Porsche System Tester II | → End | |