OBD (II) - P0010 - P0199: P0021: Diagnosis/troubleshooting
NOTE:
Fault P0021 is only entered if there is a difference of between 5°NW and 14°NW in the actual value compared with the nominal value within a period of between two and five seconds.
WORK INSTRUCTION CHART
| Work instruction | Display OK | If not OK | ||
|---|---|---|---|---|
| 1 | Read out fault memory |
|
Only fault P0021 was recorded Go to step 3 |
Fault P0011 was also recorded in the DME control module Go to step 2 |
| 2 | Check oil pressure, oil pump, pressure-regulating valve and oil type | Continue troubleshooting, Refer to LUBRICATION → End |
||
| 3 | Check magnetic hydraulic valve for leaks, check sealing strips on camshaft adjuster and camshaft adjuster itself for damage and check camshaft adjustment oil circuit for leaks and blockage | Continue troubleshooting, refer to CYLINDER HEAD, VALVE DRIVE → End |
||