LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2000 >> Boxster Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DME 7.2 - 911 CARRERA & BOXSTER >> Data output with the Porsche System Tester 2 >> Control Module Programming >> Program control unit (new control module)

Program control unit (new control module)

NOTE: The DME programming code and immobilizer code are required to program control modules. These codes can be obtained from the Porsche IPAS system. All electrical consumers must be switched off for programming control modules. Switch heater to OFF.

The vehicle battery must be fully charged.

  1. Enter vehicle identification number and confirm.
  2. Enter and confirm new programming code.
    NOTE: The new programming code must match the DME programming code from the IPAS, otherwise the control module can no longer be programmed later.
  3. Enter and confirm new immobilizer code.
    NOTE: The new immobilizer code must match the immobilizer code from the IPAS, otherwise the control module can no longer be programmed later.
  4. Select data record.
    NOTE: If the data record OBD II was selected in the old control module, the tester automatically preselects "Data record OBD II".

    The selection must then simply be confirmed. Programming commences after this confirmation.

  5. When programming is complete, switch off the ignition.
  6. Switch on the ignition.
  7. Switch off the tester.
NOTE: In Tiptronic vehicles, the fault memory of the Tiptronic must be erased following the programming of a DME control module, as the fault "CAN timeout" is entered in the memory during programming.
scientia non olet · About LEMON Manuals