LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2000 >> Boxster Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Fuel System, Electronic Injection >> Removing and installing DME control module as of ME 7.2 >> Obtaining read-out and saving vehicle data from DME control module

Obtaining read-out and saving vehicle data from DME control module

  1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch ignition on. >> to continue.
  2. Select vehicle type using the cursor keys.
  3. Using the ->| key, move from the vehicle type to the list of control units.
  4. Select DME with the cursor keys and press the >> key.
  5. Select "Control unit programming" with the cursor keys and press the >> key.
  6. Select "Read-out control unit (vehicle data)" with the cursor keys and press the >> key.
  7. The note "Vehicle data read-out complete" will appear on the screen of the Porsche System Tester.
  8. After replacement of the DME control module, the vehicle data is installed in the menu "Program control unit".
scientia non olet · About LEMON Manuals