Reading Out And Transferring Remote Control: General: Procedure:

Connect PST2 to the diagnostic plug, and switch on the ignition.
Switch on the PST2, select vehicle type Boxster and start the automatic control module search with the double arrow key >>.
After a brief search, the PST2 reports: "Fault memory reading completed".
Select Alarm system in the menu and press the double arrow key >>.
Select Learning functions from the selection list and press the double arrow key >>.
Select menu item Read out remote control and press the double arrow key >>.
The following message appears on the screen: "Input key learning code". Input the key learning code with the arrow keys v or ^ and press the double arrow key >>.
The following message appears on the screen: "Please confirm input". Check the input key learning code and press the key F7.
The following message appears on the screen: "Remote control readout in progress". Press the double arrow key [<<] twice to change to the control module overview. Switch the ignition off, remove the old control module, install the new control module and switch the ignition on again.
NOTE: The PST2 must not be switched off after the remote controls have been read out, otherwise the data will be lost and the remote controls will have to be read out again.
Press the double arrow key >> to set up communication with the new control module.
Select menu item Learning functions with the arrow key v and press the double arrow key >>.
The menu item Immobilizer is already selected. Press the double arrow key >>.
CAUTION: The immobilizer code can be input only once. An incorrect input will render the control module useless.
- Input and check immobilizer code carefully.
The following message appears on the screen: "Input immobilizer code". Input the immobilizer code with the arrow keys v or ^ and press the double arrow key >>.
The following message appears on the screen: "Please confirm input": Check the input immobilizer code and press the key F7.
Select menu item Remote control transfer with the arrow key v and press the double arrow key >>.
The following message appears on the screen: "Input key learning code". Input the key learning code with the arrow keys v or ^ and press the double arrow key >>.
The following message appears on the screen: "Please confirm input": Check the input key learning code and press the key F7.
The following message appears on the screen: "Remote controls were transferred"
Select menu item Transponder key with the arrow key ^ and press the double arrow key >>.
The following message appears on the screen: "Input key learning code". Input the key learning code with the arrow keys v or ^ and press the double arrow key >>.
The following message appears on the screen: "Please confirm input": Check the input key learning code and press the key F7.
NOTE: As the transponder coils must be taught individually, make sure that the allocation of the locations is the same as described under Transponder code on the IPAS printout (see Step 22 ).
Four unoccupied locations are displayed, and location 1 is marked in black. Additionally, the transponder code is displayed under current key. This code must be stored in the same location as specified in the IPAS printout. Select the locations and press the F8 key - the location will be allocated the associated transponder code.
Withdraw the key and repeat Steps 19 to 22 for the remaining keys.
All remote controls have now been transferred from the old control module to the new control module, and the transponders adapted to the new control module.
- Check handheld transmitter for operation (lock and unlock the vehicle)
- Check functioning of all transponder coils (engine start)
- Read out fault memory and delete any stored faults.