Ignition Lock/Switch: Installation
- If threaded bushing was removed, use 2 washers and 8 mm bolt to pull threaded bushing into steering column outer tube. Place ignition lock in position "II".
- Install ignition lock/switch on dash/steering column outer tube. Snug shear bolts, DO NOT shear off heads yet. Connect ignition switch and buzzer contact electrical connectors. Install steering wheel.
- Attach Bowden cable with ignition lock in position "II". Ensure automatic transmission selector lever is in Park and turn ignition lock to position "0". Check operation of steering column/ignition lock and shiftlock system. If operation is okay, tighten shear bolts until heads shear off.