LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Control System & Fuel System - 3.6L - Repair Instructions) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Throttle Body & Bolts
    GM1839345Courtesy of GENERAL MOTORS CORP.
  1. Position a NEW throttle body gasket to the upper intake manifold.
  2. Position the throttle body to the upper intake manifold.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the throttle body bolts and tighten to 10 N.m (89 lb in).
    4. Fig 2: MAP Sensor & ETC Electrical Connectors
    GM1838990Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2) to the ETC.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  6. Perform the Throttle Learn Procedure. Refer to Throttle/Idle Learn .
scientia non olet · About LEMON Manuals