Removal Procedure

CAUTION: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.

NOTE: Always maintain cleanliness when servicing fuel system components.

Fig 1: Fuel Fill Pipe Bolt & Fuel Fill Pocket

Courtesy of GENERAL MOTORS CORP.

Drain the fuel tank. Refer to Fuel Tank Draining (Non E-85) .
Remove the fuel fill pipe bolt from the fuel fill pocket.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 2: Underbody Fuel Fill Pipe Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the fuel fill pipe bolt from the underbody.
Disconnect and reposition the rear stabilizer shaft. Refer to Stabilizer Shaft Replacement .

Fig 3: Fuel Fill Pipe Hose Clamp & Vapor Recirculation Line Quick Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Loosen the fuel fill pipe hose clamp (1) at the fuel tank.
Disconnect the vapor recirculation line quick connect fitting (2). Refer to Plastic Collar Quick Connect Fitting Service .
Disconnect and remove the fuel fill pipe hose assembly.