LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 1.8 8, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 1.8L (Lay) - Introduction >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying O-Ring & Crank Position Sensor
    GM2016637Courtesy of GENERAL MOTORS CORP.
  1. Install the crank position sensor.
  2. Apply a light coat of engine oil to the O-ring on the crank position sensor.
    3. Fig 2: Locating Crank Position Sensor Bolt
    GM2016635Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Caution .
  3. Install the crank position sensor with the bolt.

    Tighten:  Tighten the bolt to 9.0N.m (80 lb in)

  4. Connect the crank position sensor connector.
  5. Inspect for an oil leak.
  6. Install the right engine under cover.
scientia non olet · About LEMON Manuals