LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 1.8 8, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 2.4L (Lax) - Introduction) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Caution .
    Fig 1: Exploded View Of Engine Coolant Temperature Sensor And Gasket
    GM2016558Courtesy of GENERAL MOTORS CORP.
  1. Install the engine coolant temperature sensor through a new gasket.

    Tighten:  20 N.m (14 lb ft)

    2. Fig 2: Exploded View Of Engine Coolant Temperature Sensor Connector
    GM2016551Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine coolant temperature sensor connector.
  3. Install air cleaner case.
  4. Install air cleaner cap sub-assembly with hose.
  5. Add engine coolant.
  6. Inspect for coolant leak.
  7. Install engine cover.
scientia non olet · About LEMON Manuals