LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Torrent GXP, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L - Introduction >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Fuel Tank Fill Vent Hose At Fuel Fill Tube
    GM1836302Courtesy of GENERAL MOTORS CORP.
  1. Attach the fuel tank fill vent hose to the fuel fill tube.
  2. Fig 2: View Of Closeout Grommet
    GM1418672Courtesy of GENERAL MOTORS CORP.
  3. Install the closeout grommet.
  4. Fig 3: View Of Fuel Filler Tube
    GM1418670Courtesy of GENERAL MOTORS CORP.
  5. Position the fuel fill tube (1) to the vehicle.
  6. Fig 4: View Of Fuel Filler Tube Bracket Bolts & Closeout Grommet
    GM1418669Courtesy of GENERAL MOTORS CORP.
  7. Position the fuel fill tube to the closeout grommet (1).
  8. CAUTION: Refer to Fastener Caution .
  9. Install the fuel fill tube bracket bolts (2).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  10. Fig 5: View Of Fuel Filler Pipe, EVAP Vent & Fresh Air Hoses At Fuel Tank
    GM1347586Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure that the fuel fill tube connecting hose is installed until it touches the fuel tank body. The hose clamp should be located within 13 mm (1/2 in) of the end of the connecting hose.
  11. Position the fill tube-to-fuel tank connecting hose and hose clamp.

    Tighten:  Tighten the clamp to 5 N.m (44 lb in).

  12. Connect the fuel fill vent tube and fresh air hose.
  13. Install the inner wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement .
  14. Install the wheel and tire. Refer to Tire and Wheel Removal and Installation .
  15. Lower the vehicle from the hoist.
  16. Install the fuel fill cap.
  17. Perform the Service Bay Diagnostic Test for the EVAP emission system using the scan tool. This test will verify the integrity of the vapor handling areas of the fuel system.
  18. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .