Installation Procedure
- If the air cleaner assembly was replaced, install the MAF/IAT sensor. Refer to Mass Airflow Sensor with Intake Air Temperature Sensor Replacement .
- Install the air cleaner assembly by inserting the two pins into the front panel.
- Install the air cleaner bolt.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
- Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
CAUTION:
Refer to Fastener Caution
.