LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of ECT Sensor
    GM1836047Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Component Fastener Tightening Caution .
  1. Install the ECT sensor.

    Tighten:  Tighten the sensor to 22 N.m (16 lb ft).

    2. Fig 2: Identifying Engine Wiring Harness Electrical Connectors
    GM1836029Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (4) to the ECT sensor.
  3. Fill the cooling system. Refer to Cooling System Draining and Filling (LY7 GE 47716 Fill) or Cooling System Draining and Filling (LY7 Static Fill) .
scientia non olet · About LEMON Manuals