LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Disc Brake System) >> Repair Instructions >> Front Disc Brake Pads Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668Courtesy of GENERAL MOTORS CORP.
  1. Install new anti-rattle clips to the inside ends of the caliper mounting bracket.
  2. Install the brake pads to the caliper mounting bracket.
  3. Place the new pads in the same orientation as noted during removal.
  4. Install the brake caliper. Refer to Front Brake Caliper Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Remove the safety stands.
  7. Lower the vehicle.
  8. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  9. Slowly release the brake pedal.
  10. Wait 15 seconds, then repeat steps 8-9 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  11. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling .
  12. Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing .
scientia non olet · About LEMON Manuals