LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Keyless Entry System And Remote Functions) >> Repair Instructions >> Remote Control Door Lock Receiver Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Electrical Connector At Door Lock Receiver
    GM871215Courtesy of GENERAL MOTORS CORP.
  1. Perform the following to install the door lock receiver (1) to the door lock receiver bracket.

    Slide the tab on door lock receiver (1) into the door lock receiver bracket and snap into place to secure.

  2. Connect the electrical connector (1) to the door lock receiver (2).
  3. Install the I/P trim panel. Refer to Instrument Panel Upper Trim Pad Replacement .
  4. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals