Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Torrent and 2006 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or to SIR Disabling and Enabling Zone 6 .
- Remove the center pillar lower molding. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
- Loosen the fasteners on the side impact sensor (SIS).
- Remove the SIS by sliding the module up and out of the key slots in the sheet metal.
- Disconnect the SIS electrical connector.
CAUTION:
When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
CAUTION:
Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.