LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Keyless/Power Door Locks/Security System) >> Door Lock Knob Switch Test >> Driver's Door

Driver's Door

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 10P connector (A) from the actuator (B).
    Fig 1: Identifying 10P Connector And Actuator
    G06431529Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.
    • There should be continuity between terminals No. 6 and No. 5 when the door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.
    • There should be continuity between terminals No. 7 and No. 5 when the door lock knob switch is in the UNLOCK position and no continuity when the switch is in the LOCK position.
    • Check for continuity between terminals No. 6 and No. 7 of door lock knob switch. There should be no continuity in either the LOCK or UNLOCK positions.
  4. If the continuity is not as specified, replace the driver's door latch assembly (see FRONT DOOR LATCH REPLACEMENT ).
scientia non olet · About LEMON Manuals