LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Solstice Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Ignition Switch
    GM854768Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the ignition switch and screws on to the steering column.

    Tighten:  Tighten the screws to 2 N.m (17 lb in).

  2. Connect the ignition switch harness connector.
  3. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
    NOTE: If the ignition switch is replaced and a learn procedure is not performed, the engine will crank but not start or will start and stall immediately.
  4. Perform the vehicle theft deterrent system learn procedure. Refer to Control Module References .
scientia non olet · About LEMON Manuals