LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 GXP, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.0L, 6.2L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    WARNING: Refer to Battery Disconnect Warning .
  1. Disconnect the battery ground cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine cover. Refer to Engine Cover Replacement .
    3. Fig 1: Identifying Camshaft Position (CMP) Sensor Electrical Connector
    GM1950789Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the camshaft position (CMP) sensor electrical connector (1).
    4. Fig 2: Identifying CMP Sensor To Engine Front Cover Retaining Bolt
    GM1950759Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor to engine front cover retaining bolt (1).
  5. Remove the CMP sensor (2) from the engine front cover.
  6. Remove the CMP sensor O-ring (3) from the CMP sensor and discard.

    Discard the O-ring.

scientia non olet · About LEMON Manuals