LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 GXP, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.0L, 6.2L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying CMP Sensor To Engine Front Cover Retaining Bolt
    GM1950759Courtesy of GENERAL MOTORS CORP.
    NOTE: Install a NEW O-ring to the camshaft sensor
    NOTE: Before installing the camshaft sensor, apply a small amount of clean motor oil to the O-ring (3).
  1. Install a NEW O-ring (3) to the CMP sensor.
  2. Install the CMP sensor (2) to the engine front cover.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor to engine front cover retaining bolt (1) and tighten to 25 N.m (18 lb ft).
    4. Fig 2: Identifying Camshaft Position (CMP) Sensor Electrical Connector
    GM1950789Courtesy of GENERAL MOTORS CORP.
  4. Connect the CMP sensor electrical connector (1) to wiring harness.
  5. Install the engine cover. Refer to Engine Cover Replacement .
  6. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
  7. If re-programming is required, refer to Control Module References .
scientia non olet · About LEMON Manuals