Digital Radio Receiver Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Digital Radio Receiver & Nuts

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the left rear quarter trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .
1	Digital Radio Receiver Nut (Qty: 2) CAUTION: Refer to Fastener Caution . TIP: The nuts only need to be loosened enough so that the receiver can be moved so that the nuts will fit through the keyhole slot to remove. Tighten 10 N.m (89 lb in)
2	Digital Radio Receiver Assembly Procedure Disconnect the antenna cable and electrical connectors. Reprogram the digital radio receiver after installation. Refer to Control Module References .

Callout

Component Name

Preliminary Procedure
Remove the left rear quarter trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .

Digital Radio Receiver Nut (Qty: 2)

CAUTION:

Refer to Fastener Caution .

TIP: The nuts only need to be loosened enough so that the receiver can be moved so that the nuts will fit through the keyhole slot to remove.
Tighten
10 N.m (89 lb in)

Digital Radio Receiver Assembly

Procedure

Disconnect the antenna cable and electrical connectors.
Reprogram the digital radio receiver after installation. Refer to Control Module References .