LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G8. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Battery Negative Cable To Chassis Retain Bolt
    GM1949824Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the negative battery cable to chassis retain bolt (1).

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

    2. Fig 2: Identifying Battery Positive & Negative Cables
    GM1949822Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
    IMPORTANT: Clean any existing corrosion from the battery terminal and the battery cable end.
  2. Install the negative battery cable to the battery terminal.
  3. Install the negative battery cable nut (1) to negative battery terminal.

    Tighten:  Tighten the battery terminal retaining nut to 17 N.m (13 lb ft).

  4. Install the left-hand cargo area carpet side. Refer to Rear Compartment Side Trim Panel Replacement
  5. Install the cargo area center carpet. Refer to Rear Compartment Floor Panel Carpet Replacement
scientia non olet · About LEMON Manuals