Removal Procedure

WARNING: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

WARNING: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Cover the seats and carpeting to protect them from broken glass.
Remove rear window upper garnish mould. Refer to Quarter Upper Trim Panel Replacement .
Remove the high level stop light. Refer to High Mount Stop Lamp Replacement .

Fig 1: Identifying Rear Window Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Disconnect the rear window electrical connectors (2) from the rear window (1).

Fig 2: Identifying J-36020 & Rear Window

Courtesy of GENERAL MOTORS CORP.

NOTE: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

NOTE: Use a suitable tool to install the piano wire from J-36020 (2) through the urethane at a upper corner of the rear window (1).

Install J-36020 (2) to the vehicle (3).
Connect the end of the piano wire to the other handle of J-36020 (2).

Fig 3: View Of J-36020 & Rear Window

Courtesy of GENERAL MOTORS CORP.

NOTE: Keep the inside handle of J-36020 (1) against the rear window (2) and cycle the full length of the piano wire to prevent heat build up.

With the aid of an assistant cut through the urethane bead around the rear window (2) to the vehicle (3).

Fig 4: View Of Rear Window

Courtesy of GENERAL MOTORS CORP.

NOTE: The use of suction cups will aid in the rear window (1) removal.

With the aid of an assistant remove the rear window (1) from the vehicle (2).